Dear sir:
I want to configure the AD9361 in SPI mode and in FDD state
The procedure likes the following:
Address value
0x14 0x65
0x13 0x01
I read the 0x17 Reg : it still in the ALERT state ,and setting 0x35: 09 to monitor , Control output [4] ( Tx ON) and [7] ( Rx ON) still stay low.
The question is: What is the timing that 0x14 [D5](Force Tx ON) must be set ? Is 0x65 setting correct?
Best Regards,
W.T.