Re: Problems with ADSP21262 JTAG interface and Building

Hi,

Thanks again for your help!

I used a CLKIN of 20MHz and CLK_CFG = 10 (8:1), then the target connected successfully.

Then I builded  the examples in ...\Analog Devices\VisualDSP 5.0\212xx\examples\ADSP-21262 EZ-KIT Lite, there was the error:

Failed to set automatic breakpoint at ‘main’!

My board use  ADSP-21262SBBC-150, while the ADSP-21262 EZ-KIT Lite use ADSP-21262SKBC-200. I could't find any diferences between them about memory according to the datasheet ADSP-21261_21262_21266.pdf.

When I builded my project, there was still the ‘main’ error.

Why does this happen?

Thanks,

Sophie Zhang