Hi Miguel,
Thank you for your reply.
For B at Figure 3., we intend B means U/D hold time(to CLK), and your answer before was <<t6 does not apply for this command. In this case, the description must say, U/D hold time 20ns (Vdd >2.7V) to 40ns (Vdd < 2.7V).>>.
Does it consistent to the latest answer <<cannot change the value in /U/D while /CS is low... after pull high /CS, you should apply t7.>> ?
Could you please provide correct and revised timing diagram of storage mode ?
Best Regards,